The company will try to reduce the cost and expense of cell phone jammer

 The company will try to reduce the cost and expense of cell phone jammer .
Chemical hazard: the laser system, some of the substances, such as dye, excimer, etc., is toxic and may cause harm to humans, while the laser causes a chemical reaction may produce harmful particles and gases. Fire Hazard: The dye laser is a very flammable solvent. High-voltage pulse and flashing lights may cause Mars, triggering a fire. Laser work of direct exposure to the laser process, and continuous infrared laser radiation reflected light accident, may ignite flammable materials. Other potential fire hazards, including circuit and four laser attachments flammable products. Noise, X-ray radiation, harmful gases, such as ionizing radiation, compressed gases, laser-generated suspended solids, contaminants (LGAC). Unless permitted otherwise, do not use laser or near the laser work. Unless permitted, do not enter the laser room is in operation or scope. To the laser power in the former, the device is intended to confirm correct use of safety devices. Including: opaque baffles, non-reflective surface fire, goggles, masks, door interlock and to prepare for the ventilation of toxic substances. Ensure that under pulsed laser does not inadvertently energized. Let no one in the laser care will be preceded by capacitor discharge, and turn off the power. The cell phone jammer workshop is holding a lecture to introduce importance of safety of cell phone jammer workshop.
Do not look directly to the laser beam. Commissioning and operation of the laser during the laser wear appropriate goggles. Laser debugger must be a minimum of work carried out under power. Limit exposure to the laser facility. One way is to explicitly specify the right to place a laser out of the room staff. Through to the doors unlocked, installed outside the door warning light and warning signs, etc. for access restrictions. When the laser is working, do not let the laser unattended. Take off any jewelry to avoid inadvertent reflection of the laser. Generally not necessary to monitor the laser radiation in the workplace, the risk level. This and other risk factors for different requirements. As the laser beam highly directional, and can not change the optical path, the laser radiation detector is expensive, complex structure, the general safety requirements are not subject to on-site monitoring, but the emphasis on control of the risk level of the laser device, it should be equipment suppliers responsible for the measured device is standard. According GB/Z18461-2001 Safety of Laser Products - Producers of laser radiation safety checklist. The better the machining process is, the better the quality of cell phone jammer is.